5-37n005 : Stopping Method Factory setting: 0Range: 0 to 1Selects the stopping method suitable for the application.Setting Description0 Deceleration (ramp) to stop1 Coast to stopA. Data 0 : Deceleration to StopUpon removal of the FWD (REV) Runcommand, the motor decelerates at thedeceleration rate determined by the timeset in Decel Time 1 (n020 ), and DCinjection braking is applied immediatelybefore stop. If the decel time is too shortor the load inertia is too large, an over-voltage (OV) fault may occur on a stopcommand — the decel time must beincreased.B. Data 1 : Coast to StopUpon removal of the FWD (REV) Run command, the motor coasts to rest.5.24 STOPPING METHODOutput FrequencyRun Command ON OFFDecel Time 1(n020 )Min. Output Frequency(Frequency at DC InjectionBraking Start) (n016 )DC Injection BrakingTime at Stop (n090 )(Factory setting: 0.5 s)Output FrequencyRun Command ON OFFDrive output is shut OFFwhen stop command is input
