YASKAWA VIPA IM 053EC Manual
Also see for VIPA IM 053IP: Manual
                                                                                                      | |
Contents
| 
4.2.2 HotConnect via Configured Station AliasThe specification of the HotConnect address via Configured Station Alias happens as fol-lows:1. In your configuration tool, connect to the corresponding slave station. This must bein the INIT state.2. Adjust the Configured Station Alias in the SII (EEPROM).3. Perform a power cycle.ð The value set in the SII is used as Configured Station Alias.Information on how to enter an ESC register and a Configured StationAlias address in your configuration tool can be found in the associatedmanual.For example, in the EtherCAT Manager you must open the ‘Advancedoptions’ of the slave station in your configuration, activate ‘Checkidentification’ and enter the ESC register address 0x0012 at ‘Select localaddress’ . In this case, the Configured Station Alias address must bespecified in ‘Diagnostics mode’ via ‘EEPROM’ and in ‘Group’ via‘Identification value’ .ProceedingVIPA System SLIO DeploymentSetting the HotConnect address > HotConnect via Configured Station AliasHB300 | IM | 053-1EC01 | en | 18-49 49 |
Related manuals for YASKAWA VIPA IM 053IP
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine