Yaesu FT3DR Operating Manual

Also see for FT3DR: Instruction manual Instruction manual Operating manual Instruction manual Advanced manual

24Using the MemoryCautionThe information registered to memory channels can be corrupted by incorrect operation, staticelectricity, or electrical noise. Also, it can be erased in the event of a failure or repair. Be sureto keep a record of the settings on paper or back up the data to the microSD memory card. Fordetails on saving a backup onto a microSD memory card, see “Set Mode: SD CARD Menu Opera-tions” on page xxx.Registering to Memory Channels1. Set the frequency and the communication mode to beregistered to a memory channel.2. Touch and hold [F MW].3. Rotate the DIAL knob to select the desired channelnumber.4. Touch [M.WRITE].If you attempt to register a frequency to a memo-ry channel that already contains frequency data,“OVERWRITE?” will appear on the LCD. Touch [OK]twice to overwrite the memory channel.The beep sounds and the memory is saved.Recalling a Memory Channel1. Press the [V/M] key.The memory channel most recently used appears on the display.2. Rotate the DIAL knob to select the desired memory channel.3. Press the [V/M] key to exit the memory mode, and return to the normal operation. The data registered to a memory channel can be transferred to the VFO operating bandby following the procedure below:Touch and hold F MW £ Touch [ ] £ Touch [V.WRITE £ “OVERWRITE?”appears £ Touch OK twice. The transceiver may be placed into a Memory Channel Only mode, (which restrictsthe FT3DR to operate only on the memory channels), by pressing the [V/M] key, whilepressing the Power (Lock) switch to turn the transceiver ON. To cancel the MemoryChannel Only mode, turn the transceiver OFF, then press the [V/M] key again, whilepressing Power (Lock) switch to turn the transceiver ON.