Yaesu FTM-10R Operating Manual

Also see for FTM-10R: Brochure & specs Technical supplement Manual Easy Programming Guide

51FTM-10R O PERATING M ANUALMESSAGE F EATURECloning1. Bring the Source Transceiver and the Destination Transceiver as close to each other aspossible.2. Press the top panel’s PTT key on the Source Transceiver.While transmitting the clone data, the Source Transceiver’sLED blinks red and blinks the “SENDING” notation on theLCD.When clone data has finished transmitting, the SourceTransceiver’s LED blinks white for around 3 seconds andthen displays “ALL” and “SENT OUT” on the LCD. Then,the “TX CLONE” notation and the Club Channel frequencyappears on the display alternately again.To finish the Cloning, turn the radio off by pressing and holding the [POWER] key fortwo seconds.3. The Destination Transceiver does not require any set -up operation.4. When receiving cloning data from the “Source Transceiver”, the “Destination Trans-ceiver” automatically stores all the data, and the LED blinks white for 3 seconds, thendisplays “ALL” and “RECEIVED” on the LCD. Then, the“Destination Transceiver” turns off automatically, and turnson again. The radio returns to normal operation in the VFOor memory mode, as before the Clone operation began. Thecopy/clone procedure is completed.If “ERROR” is displayed on the LCD screen while doing the Clone procedure, the clon-ing process was not successful. In this case, turn the radio off and retry the cloningprocedure. In the case of repeated cloning failures, see the following information.The distance of the transceivers (source transceiver and Destination Transceiver) has tobe close.Check any equipment in the area that may be generating electrical noise. This mayinterrupt data transfer.