Yaesu FTM-10R Operating Manual

Also see for FTM-10R: Brochure & specs Technical supplement Manual Easy Programming Guide

78 FTM-10R O PERATING M ANUALMISCELLANEOUS S ETTINGREPEATER S HIFT D IRECTIONYou may select the Repeater Shift Direction.1. Press and hold the [VOL/SEL] key for one second to activate the Menu mode.2. Rotate the DIAL knob to select Menu Item “F25 RPT MODE”.3. Press the key to enable selection of this Menu Item.4. Rotate the DIAL knob to select desired shift direction (RPTR-, RPTR+, or RPTR OFF).5. Press the [VOL/SEL] key momentarily to save the new setting and exit to normal op-eration.The repeater offset is fixed to 600 kHz on the 144 MHz band and 5 MHz on the 430 MHzband from the factory. You can change the offset via the Menu mode “F26 RPT SFT”.REPEATER S HIFT O FFSET1. Press and hold the [VOL/SEL] key for one second to activate the Menu mode.2. Rotate the DIAL knob to select Menu Item “F26 RPT SFT”.3. Press the key to enable selection of this Menu Item.4. Rotate the DIAL knob to select desired offset.5. Available selections are 0.00 - 99.95 MHz (50 kHz increments).6. Press the [VOL/SEL] key momentarily to save the new setting and exit to normal op-eration.AUTOMATIC R EPEATER S HIFTThe ARS (Automatic Repeater Shift) feature in this transceiver allows easy and convenientrepeater operation by automatically activating the repeater shift function whenever youtune to a frequency in a standard repeater sub band. The ARS function is preset at thefactory to conform to the standards for the country to which it is exported.The ARS function is enabled at the factory. To disable ARS:1. Press and hold the [VOL/SEL] key for one second to activate the Menu mode.2. Rotate the DIAL knob to select Menu Item “F24 RPT ARS”.3. Press the key to enable selection of this Menu Item.4. Rotate the DIAL knob to change the display to “OFF”.5. Press the [VOL/SEL] key to save the new setting and exit to normal operation.To enable the ARS function again, just repeat the above procedure, rotating the DIAL knobto select “ON” in step 4 above.