VX-3R O PERATING M ANUAL58MEMORY SCANNINGMemory scanning is also easy to initiate:1. Set the radio to the Memory mode by pressing the [V/M] key, if necessary.2. Press and hold in the [BAND] key for one second, and rotate theDIAL knob while holding in the [BAND] key to select the de-sired Memory Scan mode. Available selections are ALL CHALL CHALL CHALL CHALL CH,TAG1TAG1TAG1TAG1TAG1, TAG2TAG2TAG2TAG2TAG2, BANDBANDBANDBANDBAND, and PMS-XPMS-XPMS-XPMS-XPMS-X.ALL CHALL CHALL CHALL CHALL CH: The scanner sweeps all Memory channels.TAG1TAG1TAG1TAG1TAG1: The scanner sweeps only those Memory channels with the same first digit ofthe alpha/numeric tag as the first channel on which scanning started.TAG2TAG2TAG2TAG2TAG2: The scanner sweeps only those Memory channels with the same first andsecond digits of the alpha/numeric tag as the first channel on which scanningstarted.BANDBANDBANDBANDBAND: The scanner sweeps only those Memory channels which are memorized onthe same operating band as the first channel on which scanning started.PMS-XPMS-XPMS-XPMS-XPMS-X: The scanner will sweep frequencies within the currently-selected PMS fre-quency pair. See page 61 for details.Note: Do not forget to pull the DIAL knob to rotate the DIAL knob.3. Release the [BAND] key to initiate scanning.4. As with VFO scanning, the scanner will halt on any signal encountered that is strongenough to open the squelch; it will then resume scanning accord-ing to the Scan-Resume mode set previously. When there are nomemory channels corresponding to the selected Memory Scanmode, the “MS ERRMS ERRMS ERRMS ERRMS ERR” notation will appear on the display.5. To cancel scanning, press the PTT switch or [V/M] key.SCANNING