60H5E113Engine idle speed : 675-725 r/minControl system3-163. Check that the accelerator cam 3 isaligned with the centerline of the roller 4.60H303904. Loosen the throttle lever tightening screw5 clockwise to make the accelerator camaligned with the centerline of the roller 4.5. Tighten the throttle lever tightening screw5 counterclockwise.NOTE:The throttle lever tightening screw 5 has lefthand threads.6. Start the engine and adjust the engine idlespeed by turning the idle adjusting screw.Adjusting the choke solenoid1. Remove the intake silencer.2. Make sure that the choke valve is fully open.3. Check that the choke solenoid face A isbetween the marking B on the plunger.Adjust the position of the choke solenoid ifnecessary.60H30400Adjusting the throttle link and thethrottle cable operationNOTE:Complete the ignition timing adjustment,throttle valves synchronization, engine idlespeed adjustment, and carburetor pickup tim-ing adjustment prior to the throttle link adjust-ment.1. Loosen the locknut 1 , remove the clip 2,and disconnect the throttle cable joint 3.60H304102. Adjust the length of the throttle cable joint3 so that its hole is aligned with the setpin on the magnet control lever.60H3041560H30420The throttle cable joint must be screwed ina minimum of 8.0mm (0.31in.) A.
