Yamaha 55DEHD Service Manual

Also see for 55DEHD: Rigging guide Rigging guide

6885J11 7-32987654321Clamp bracket and swivel bracketInstalling the PTT unit (ET)1. Fully tilt the outboard motor up, and thensupport it with the tilt stop lever 1.w9 When installing the PTT unit withoutremoving the power unit, be sure to sus-pend the outboard motor. Otherwise, theoutboard motor could suddenly fall andresult in injury.9 After tilting the outboard motor up, besure to support it with the tilt stop lever.2. Install the bushing 2 and 3.3. Lift the PTT unit 4 up and install the PTTunit mounting bolts 5, and then tightenthem.4. Install the tilt ram upper end into the swiv-el bracket with the pin 6 and circlip 7.168870475Assembling the swivel bracket (ET)NOTE:To assemble the swivel bracket, refer to page7-24.Installing the clamp bracket (ET)1. Install the trim sensor 1, and then tight-en the screws 2.2. Install the bushings 3 into the swivelbracket 4, then install the swivel bracket4, washers 5, clamp brackets 6, andthrough tube 7.NOTE:Adjust the trim sensor cam after installing thePTT, refer to page 7-33.3. Install the self-locking nut 8 temporarily.4. Install the ground lead between theclamp brackets and the swivel bracket.12688704508765 36534688704605733 22564 68870485