Operation35make sure there is no hesitation in theirtravel. Operation should be smooth overthe complete range of motion, and each le-ver should return completely to the idle po-sition. Look for loose or damaged connections ofthe throttle and shift cables.EMU36481Engine shut-off cord (lanyard)Inspect the engine shut-off cord for damage,such as cuts, breaks, and wear.EMU27166Engine oil1. Put the outboard motor in an upright po-sition (not tilted). NOTICE: If the motoris not level, the oil level indicated onthe dipstick may not be accurate.[ECM01790]2. Remove oil dipstick and wipe it clean.3. Insert the dipstick and remove it again.Be sure to completely insert the dipstickinto the dipstick guide, otherwise the oillevel measurement will be incorrect.4. Check the oil level using the dipstick tobe sure the level falls between the upperand lower marks. Fill with oil if it is belowthe lower mark, or drain to the specifiedlevel if it is above the upper mark.1. Cord2. Clip3. Engine shut-off switch1. Cord2. Clip3. Engine shut-off switch213ZMU020031. Oil dipstick1. Lower level mark2. Oil dipstick3. Upper level markZMU055981ZMU020821 3 2
