CRANKSHAFT5-8011. Install:• Cylinder assembly “1”• Connecting rod caps “2”NOTE:• Make sure that the “Y” marks “a” on the con-necting rods face towards the left side of thecrankshaft.• Make sure that the characters on both theconnecting rod and connecting rod cap arealigned.12. Tighten:• Connecting rod bolts▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼CAUTION:ECA14980Tighten the connecting rod bolts using theplastic-region tightening angle method.a. Clean the connecting rod bolts.b. Tighten the connecting rod bolts.c. Put a mark “1” on the connecting rod bolt“2” and the connecting rod cap “3”.d. Tighten the bolt further to reach the speci-fied angle (150°).e. After the installation, check that the sectionshown “a” is flush with each other by touch-ing the surface.WARNINGEWA13990• When the bolt is tightened more than thespecified angle, do not loosen the boltand then retighten it. Replace the boltwith a new one and perform the proce-dure again.Connecting rod bolt20 Nm (2.0 m·kg, 14 ft·lb)+150°a. Side machined face
