INSTRUMENT AND CONTROL FUNCTIONS4-4123456789101112RightEAU66091Pass/LAP switch “ /LAP”Press this switch to flash the headlightsand to mark the start of each lap whenusing the lap timer.EAU66020Dimmer switch “ / ”Set this switch to “ ” for the highbeam and to “ ” for the low beam.EAU66040Turn signal switch “ / ”To signal a right-hand turn, push thisswitch to “ ”. To signal a left-handturn, push this switch to “ ”. When re-leased, the switch returns to the centerposition. To cancel the turn signallights, push the switch in after it has re-turned to the center position.EAU66030Horn switch “ ”Press this switch to sound the horn.EAU66060Stop/Run/Start switch “ / / ”To crank the engine with the starter, setthis switch to “ ”, and then push theswitch down towards “ ”. See page6-1 for starting instructions prior tostarting the engine.Set this switch to “ ” to stop the enginein case of an emergency, such as whenthe vehicle overturns or when the throt-tle cable is stuck.EAU67360The engine trouble and system warninglight and ABS warning light may comeon when the key is turned to “ON” andthe start switch is pushed, but this doesnot indicate a malfunction.EAU66010Hazard switch “ ”With the key in the “ON” or “ ” posi-tion, use this switch to turn on the haz-ard lights (simultaneous flashing of allturn signal lights).The hazard lights are used in case ofan emergency or to warn other driverswhen your vehicle is stopped where itmight be a traffic hazard.NOTICEECA10062Do not use the hazard lights for anextended length of time with the en-1. Mode switch “MODE”2. Up button3. Center button4. Down button1. Stop/Run/Start switch “ / / ”2. Wheel switch “ ”1243122CR-9-E0_1.book 4 ページ 2015年1月5日 月曜日 午前11時54分