19EnglishINTRODUCTION PREPARATIONBASICOPERAIONTADVANCEDOPERATIONADDITIONALINFORMATION APPENDIXCONNECTIONSConnecting the Power Supply Cords Connecting the AC power cord[U.S.A. and Canada models]Plug the power cord into the AC inlet when allconnections are complete, and then plug in this unit to thewall outlet.Caution• Do not use other AC power cords than the one provided.Otherwise it may result in causing fire or an electricalshock.[Australia, China and General models]Plug in this unit to the wall outlet. AC OUTLETS (SWITCHED)U.S.A., Canada, China andGeneral models ............................................ 3 OUTLETSAustralia model .............................................. 1 OUTLETUse these outlets to connect the power cords from yourcomponents to this unit. The power to the AC OUTLETSis controlled by this unit’s STANDBY/ON (or SYSTEMPOWER and STANDBY). These outlets will supplypower to any connected component whenever this unit isturned on. The maximum power (total powerconsumption of components) that can be connected to theAC OUTLETS is 100 W for U.S.A., Canada and Australiamodels and 50 W for China and General models. VOLTAGE SELECTOR(China and General models only)The VOLTAGE SELECTOR on the rear panel of this unitmust be set for your local main voltage BEFOREplugging into the AC main supply. Voltages are 110/120/220/240 V AC, 50/60 Hz.(U.S.A. model)IMPEDANCE SELECTORSET BEFORE POWER ONREAR :REAR CENTER :CENTER :MAIN A OR B :A B :REAR :REAR CENTER :CENTER :MAIN A OR B :+4ΩMIN. /SPEAKER4ΩMIN. /SPEAKER4ΩMIN. /SPEAKER4ΩMIN. /SPEAKER8ΩMIN. /SPEAKER8ΩMIN. /SPEAKER8ΩMIN. /SPEAKER8ΩMIN. /SPEAKER8ΩMIN. /SPEAKERAC OUTLETSSWITCHED100W MAX. TOTALIMPEDANCE SELECTORSET BEFORE POWER ONREAR :REAR CENTER :CENTER :MAIN A OR B :A B :REAR :REAR CENTER :CENTER :MAIN A OR B :+4ΩMIN. /SPEAKER4ΩMIN. /SPEAKER4ΩMIN. /SPEAKER4ΩMIN. /SPEAKER8ΩMIN. /SPEAKER8ΩMIN. /SPEAKER8ΩMIN. /SPEAKER8ΩMIN. /SPEAKER8ΩMIN. /SPEAKERAC OUTLETSVOLTAGE SELECTOR240VSWITCHED100W MAX. TOTALVOLTAGE SELECTOR(China and General models)To AC outlet