69EnglishINTRODUCTION PREPARATIONBASICOPERAIONTADVANCEDOPERATIONADDITIONALINFORMATION APPENDIX Example of a system configuration and connectionsNotes• When not using the main room, turn down the volume of this unit in the main room. Adjust the Zone 2 volume with the control onthe amplifier in the second room.• DO NOT USE the Zone 2 feature for CDs encoded with DTS to avoid unexpected noise.ZONE 2You can make up a multi-room audio-video system with this unit. This feature enables you to set this unit to reproduceseparate input sources in the main room and second room (Zone 2) with the supplied remote control in the second room.Only analog signals are sent to the second room. For any source you want to listen to in the second room, you mustconnect the analog output jack from the source to the corresponding analog input jack on this unit.Zone 2 ConnectionsTo use the multi-room functions of this unit, you need the following additional equipment:• An infrared signal receiver in the second room• An infrared emitter in the main roomThis emitter transmits the infrared signals from the remote control in the second room to the main room(for example, to a CD player or LD player)• An amplifier and speakers for the second room• A video monitor for the second roomREMOTE CONTROL OUTREMOTE CONTROL OUTDVD INPUTREMOTE CONTROL INZONE 2 VIDEO OUTZONE 2 AUDIO OUTOUT IN OUT IN REMOTECONTROL OUTMain roomInfrared signalreceiverRemote controlSecond roomAmplifierInfrared emitterThis unitDVD player(or other component)This unity• Since there are so many ways to connect and use this unit in amulti-room installation, we recommend that you consult withthe nearest authorized YAMAHA dealer or service center forthe Zone 2 connections which will best meet yourrequirements.• Some YAMAHA models are able to connect directly to theREMOTE CONTROL OUT jack of this unit. If you own theseproducts, you may not need to use an infrared emitter. Up to 6YAMAHA components can be connected as shown.Videomonitor