Yealink W60B Configuration Manual

Also see for Verizon One Talk W60B: Getting started Recovery guide Configuring guide User guide How to configure

Yealink W60B Configuration Manual Manual pdf 18 page image

BROADSOFT PARTNER CONFIGURATION GUIDE – YEALINK W60B IP DECT PHONE 20-BD5561-00©2018 BROADSOFT INC. PAGE 18 OF 1174 W60B IP DECT PHONE ConfigurationThis section describes the configuration settings required for the W60B IP DECT PHONEintegration with BroadWorks, primarily focusing on the SIP interface configuration. TheW60B IP DECT PHONE configuration settings identified in this section have been derivedand verified through interoperability testing with BroadWorks. For configuration details notcovered in this section, see the Yealink W60B IP DECT PHONE User Guide [1].4.1 Configuration MethodThe capabilities of the W60B IP DECT PHONE have been verified for use withBroadWorks based on the settings described in the following table. For more informationon the meaning, purpose, and applicability of the individual configuration items see theYealink W60B IP DECT PHONE User Guide [1].Configuration FilesFiles Provided by Partner Level Descriptiony0000000000.cfg system configuration file “y0000000000xx.cfg”, where “xx”is associated with the hardwareversion of Yealink Device..cfg device-specificconfiguration fileDevice specific accountinformation file.4.2 System Level ConfigurationThis section describes system-wide configuration items that are generally required foreach W60B IP DECT PHONE to work with BroadWorks. Subscriber-specific settings aredescribed in the next section.Step Command PurposeSystem Configuration Items y0000000000.cfgStep 1 Set SIP Proxy/Domain.account.1.sip_server_host =as.broadworks.netaccount.1.SIPServerPort = 5060account.1.sip_server_type = 2Set the W60B IP DECT PHONE SIPserver to the Fully Qualified DomainName (FQDN) for the BroadWorksApplication Server cluster.The domain must match the domainconfigured for the BroadWorkssubscriber’s line/port domain.Set the SIP server type of W60B:Default=0BroadSoft=2Step 2 Set Outbound Proxy.account.1.outbound_proxy_enable =1account.1.outbound_host =sbc.broadworks.netaccount.1.outbound_port = 5060Set the Outbound Proxy to thesession border controller (SBC) if oneis deployed between the W60B IPDECT PHONE and BroadWorks.If there are redundant SBCs, set it tothe FQDN for the SBC cluster.Step 3 Set SIP Timers.sip.timer_t1 = 0.5sip.timer_t2 = 4sip.timer_t4 = 5The SIP timers should be set to levelsshort enough to support a timelyfailover when there is no serverresponse.