BROADSOFT PARTNER CONFIGURATION GUIDE – YEALINK W60B IP DECT PHONE 20-BD5561-00©2018 BROADSOFT INC. PAGE 34 OF 1175.2 Device Management ConfigurationThis section identifies the steps required to enable the Yealink W60B IP DECT PHONE fordevice management. For Device Management configuration details not covered here, seethe BroadWorks Device Management Configuration Guide [2] and the BroadWorks CPEKit Usage Guide [8].5.2.1 Configure BroadWorks TagsThe template files in Device Management use tags to represent the data stored onBroadWorks. When a configuration changes for a user, Device Management parses thetemplate files and replaces the Device Management tags with the associated data storedon BroadWorks. There are default tags defined in the Device Management software andthere are custom tags that the service provider can create/define via the web portal for useby Device Management. There are two types of custom tags that can be defined:system-default tags are common to all phones on the system; device-type-specific tagsare common to Yealink W60B only.The Yealink W60B IP DECT PHONE makes use of dynamic tags, which may beconfigured by a BroadWorks administrator as either system default or device type specifictags. This section identifies the required tags.5.2.1.1 Create System Default TagsBrowse to System → Resources → Device Management Tag Sets and select the SystemDefault tag set. Add the system default tags in the following table if they do not alreadyexist.Tag Name Valid Settings Description%SNTP_SERVER_1% IP address/FQDN NTP server address.%SNTP_SERVER_2% IP address/FQDN NTP server address alternate.%DNS_SERVER_1% IP address DNS server address.%DNS_SERVER_2% IP address DNS server address alternate.%SBC_ADDRESS% IP address/FQDN SBC SIP address.%SBC_PORT% Port SBC SIP port.%USE_SBC_BOOLEAN% 0/1 Use SBC: 1=yes, 0=no.%XSP_ADDRESS_XSI_ACTIONS%IP address/FQDN Xtended Services Platform serveraddress.