Yealink W60B Configuration Manual

Also see for Verizon One Talk W60B: Getting started Recovery guide Configuring guide User guide How to configure

Yealink W60B Configuration Manual Manual pdf 23 page image

BROADSOFT PARTNER CONFIGURATION GUIDE – YEALINK W60B IP DECT PHONE 20-BD5561-00©2018 BROADSOFT INC. PAGE 23 OF 117Step Command PurposeStep 4 Configure display name.Example:account.1.Display_Name = Joe Brown;Configure the name to bedisplayed on the device for thisline.The following steps are used to configure line 2 for Joe’s phone. This line rings when Bobis called, so it has Bob’s authentication information.Step Command PurposeStep 1 Configure line as shared.account.2.shared_line = 1;Configure the line as “shared”(as opposed to “private”).Step 2 Set Register User ID.Example:account.2.user_name = 2405552222_2;The register user ID mustcorrespond with the line/portsetting on BroadWorks.Step 3 Enable SIP Authentication.Example:account.2.Auth_Name = bobsmith;account.2.password password = bobs;If the Authentication service isconfigured on BroadWorks,these parameters must beconfigured to match theBroadWorks settings.This line rings when Bob iscalled, so it has Bob’sauthentication information.Step 4 Configure display name.Example:account.2.Display_Name = Bob Smith;Configure the name to bedisplayed on the device for thisline.4.4.1.3 Hybrid Key System ConfigurationYealink W60B IP DECT PHONE does not support Hybrid Key System.4.4.2 Busy Lamp Field ConfigurationYealink W60B IP DECT PHONE does not support Busy Lamp Field.4.4.3 Feature Key Synchronization ConfigurationFeature Key Synchronization provides synchronization of phone services such as CallForwarding and Do Not Disturb with the settings on BroadWorks for the analogousservices. Configure the phone to enable Feature Key Synchronization as follows:Step Command PurposeStep 1 Enable Feature Key Synchronization.Example:features.feature_key_sync.enable = 1Enable Feature KeySynchronization feature. 0 for Disabled 1 for EnableBrowse to Features → General Information and set Feature Key Synchronization to“Enabled”.