8 Start-up8.1 Prerequisites for commissioningAttention!1. You must mount and connect the device in accordance with the operating instructions.2. Double check that all connections are correct.3. The mains voltage must match the information on the rating plate.4. The rated current on the rating plate will not be exceeded.5. Make sure that no persons or objects are in the hazardous area.8.2 Procedure for commissioningSequence Setting1 " Check if Thermostats or Thermistors of the motor are connected to input “TB/TP In”." If the motor protection function of the device is not neccesary the both terminals “TB / TP” have to be bridged.2 " Check connection and close housing carefully.3" Turn on mains voltage.Display after first turning on the mains voltage4InformationIn the menu group Start the adjustment for Motor is OFF for factory setting => display: |STOP|.This prevents the system from inadvertently starting up before configuration is complete.Switch over via |Menu| to Main menue5Menu group: Start" Set the menu language if necessary (factory setting English = Language GB)." The display can be switched between SI units (US units = OFF) and imperial (US) units (US units = ON).6Menu group: Base setup" Setting the desired operation Mode (factory setting 1.01 = Speed controller Selection Mode)." Further settings depend on the selected mode and the sensor / setting signal used.Attention!When saving the operating mode, the respective preset factory operating-mode setting is loaded. That means,the settings you have made, e.g., in “Motor setup” are lost. An exception: the menu language setting remainspreserved.7The Motor Setup factory installed values are for variable voltage external rotor motors 400 V / 50 Hz. Afterchecking of the motor data the setting are to be adapted if necessary.Motor rated voltage(see Rating plate)SettingEdgefrequencySettingMax. Frequency3 ~ 400 V, 50 Hz 48.5 Hz 50 Hz3 ~ 400 V, 50/60 Hz 48.5 Hz 60 Hz3 ~ 400 V, 60 Hz 57 Hz 60 HzAdditional settings Operating Instructions / Motor Setup.8 Menu group Setting:" Set the parameters for the control operation9 Menu group Start:" Switch setting for Motor to ON.Operating Instructions Fcontrol – model series FXDM25/32AM Start-upL-BAL-E212-GB 1451 Index 003 Part.-No.29/123
