Info Current actual value measured at sensor 1 (unit depending on programming).0 °CE1 ActualInfo Display for “actual value 2” for operation with two sensors.Display if function not active: | - - - - - |0 °CE2 ActualInfo Display of the active target value at which the device operates.“Setpoint1” Menu “Setting”“Setpoint2” Menu “Setting”“Ext. Setpoint” = setting by external signal 0-10 V. With activated manual mode thedisplay constantly changes between actual value and value for manual mode.Display for operation with two control circuits:“1.Setpoint 1” or “1.Setpoint 2” for control circuit 1“2.Setpoint 1” or “2.Setpoint 2” for control circuit 20 °CSetpoint1Info Only for mode 4.02 , 4.03 , 5.02 with setpoint depending on outdoor temperature (E2function = |6E|).100.0 PaSetpoint controlInfo Inverter output frequency.0.0 HzFrequencyInfo “2. Modulation” for control circuit 2(Only active in operation with a second control circuit)0 %1. ControlInfo Display of motor current (Metering precision approx. +/-10%)0.0 AMotor currentInfo Momentarily status for minimum speed cut off“ON” = switch off, if Setpoint (+/- “Min. speed cut off”) is reached.“OFF” = no switch off that means operation with minimum rate of air.Display for operation with two control circuits:“1. Min. speed cut off” for control circuit 1“2. Min. speed cut off” for control circuit 2OFFMin. speed cut offOperating Instructions Fcontrol – model series FXDM25/32AM ProgrammingL-BAL-E212-GB 1451 Index 003 Part.-No.55/123
