Setting Min. Speed (basic speed only when needed)Setting range: |OFF| → “Shutdown Freq.” ( Motor Setup) - “Max. Speed”.Factory setting: |OFF |OFFMin. SpeedSetting Max. Speed (speed limitation only when needed)Setting range: “Max. Frequency” ( Motor Setup) - “Min. Speed”Factory setting: 50.0 Hz50.0 HzMax. SpeedSetting Manual mode“OFF” = automatic control as function of the set parameters (Factory setting)“ON” = automatic control without function, speed setting in menu “Speed manual”OFFManual modeSetting Speed Manual modeManual speed setting without influence by the external signal.Activation by menu “Manual mode” or external contact at digital input ( IO Setup).Setting range: 0... “Max. Frequency” ( Motor Setup)Factory setting: 50.0 HzFor information about deactivated regulation the adjusted value for manual speed isindicated alternating with the actual value.50.0 HzSpeed man.Additional menu item for mode 4.02 and 4.03 with outside-temperature dependent target-setpoint.Outside-temperature dependent target-setpointATP-min.-15 °CT-min.30 °CT-StartS118.09.2014v_pressure_set_dep_outtemp.vsd[Pa]S2T-BandS1 Setpoint1S2 Setpoint2P-min. Min. SetpointT-min Min. temperatureT-Start Setpoint reducing will start below this outside temperatureT-band Temperature rangeAT Outdoor temperatureAn outside temperature compensation can beactivated (sensor connection “E2” = “Analog In2”) when being operated as a pressure regula-tion device.An optimal building climate, e.g., can beachieved through this. Through this function,the set and active “Setpoint1” or “Setpoint2” isautomatically changed proportional to themeasured outside temperature ( Info: “Set-point control”).Setting T-Band SATemperature range in which the setpoint change continiously with outside temperatureSetting range: 0.0..100.0 KFactory setting: 30.0 K30 KT-Band SASetting T-Start SASetpoint reducing will start below this outside temperatureSetting range: -10.0...40.0 °CFactory setting: 15.0 °C15 °CT-Start SAOperating Instructions Fcontrol – model series FXDM25/32AM ProgrammingL-BAL-E212-GB 1451 Index 003 Part.-No.47/123
