ZIEHL-ABEGG Fcontrol FKDM..-C Series Operating Instructions Manual

Contents

Motor Setup Rampdown timeTime setting in which the automatic controller output from 100 % to 0 % reduces.Setting range: 0...250 sec.Factory setting: 10 / 20 / 30 / 40 sec. (depending on device type)40 secRampdown time0 .. 100 %3412 09.05.2007v_hochlaufzeit_ruecklaufzeit.vsd1 external Signal2 Setting3 Rampup time4 Rampdown time9.8.5 Setting Rolling direct.Attention!The directionof rotation of the motor must be checked during initial commissioning ( arrow).We will not under any circumstances provide a guarantee for damage due to incorrect motordirection of rotation!When connected in accordance with the connection diagram, the standard rotary direction “RIGHT” =|CW| results under factory settings. A change of direction is feasible by exchanging the phasesequence in the motor connection or through reprogramming.Motor Setup Rolling direct.By selecting the parameter “Rotat. Direction” the rotationdirection can be changed to |CCW| for “LEFT HAND” direc-tion of rotation.Pressing the Enter key causes the value that has been set tobe accepted.Motor SetupCWRolling direct.CCWRolling direct.If the rotary direction is reversed with an available modulation, it is initially reduced to “0” (discon-nected) and subsequently increased back to the default value.9.8.6 Setting Current limitMotor Setup Current limitAs an additional safety function the device has a current limit, this can be adapted ifnecessary.The setting refers to the motor rated current of the device (100 % = setting: MotorRa-tedCurr.).On exceeding the percentage value set here, the modulation is reduced until the setcurrent is set again. This prevents overloading of the motor.Setting range: 100...200 %Factory setting: 160 %160 %Current limitInfo OLThe active current limit is indicated in the display by the symbol OL23.4 °CE1 ActualOperating Instructions Fcontrol – model series FKDM25/32AM-C ProgrammingL-BAL-E214-GB 1446 Index 002 Part.-No.70/99