e-conolight E-WFS Series Installation Instructions Manual

Contents

important safeguards

e-conolight E-WFS Series Installation Instructions Manual Manual pdf 1 page image

Document: DateCreated By: ECO#LPN00662X0001A0_A 9-16-2019TMT 011012INSTALLATION INSTRUCTIONSE-WFS Serieswww.e-conolight.com | 888.243.9445 | FAX: 262.504.5409CAUTIONSIMPORTANT SAFEGUARDSWhen using electrical equipment, basic safetyprecautions should always be followed including thefollowing:READ AND FOLLOW ALLSAFETY INSTRUCTIONS1. DANGER- Risk of shock- Disconnect power beforeinstallation.DANGER – Risque de choc – Couper l’alimentationavant l’installation.2. This luminaire must be installed in accordance with theNEC or your local electrical code. If you are not familiarwith these codes and requirements, consult a qualifiedelectrician.Ce produit doit être installé conformément à NEC ou votrecode électrique local. Si vous n’êtes pas familier avec cescodes et ces exigences, veuillez contacter un électricienqualifié.3. Suitable for Wet Locations.Adspte pour les Endroits Mouiles.4. WALL MOUNT ONLY.INSTALLATION MURALE SEULEMENTSAVE THESE INSTRUCTIONSFOR FUTURE REFERENCE1. Remove the quick mount bracket from the fixture base byloosening the two set screws. See Figure 1.2. Install the quick mount bracket on a junction box at the intendedlocation using hardware supplied with junction box. Make surearrow on the bracket is pointing up. A high grade caulkingmaterial, such as silicone rubber, should be used between gasketon bracket and mounting surface.NOTE: The bubble level on the quick mount bracket can be usedto ensure the bracket is mounted level.3. Pull supply leads through center hole in quick mount bracket.4. Attach the aircraft cable hook from the fixture base to the centerhole in the quick mount bracket to support the fixture.5. Make wiring connections per the Electrical Connections section.6. While holding fixture, remove aircraft cable from the fixture baseby removing screw holding cable in place. Discard cable and hook.7. Attach fixture base to the quick mount bracket by hooking topof bracket into the angled bracket on the back side of the fixturebase. Next, lower the fixture until base sits flush with mountingsurface.8. Secure the fixture base to the quick mount bracket by tighteningtwo set screws on bottom of the fixture base.9. Apply a high grade caulking material, such as a silicone rubber,between the fixture base and the mounting surface. Make surecaulking material is also applied at the set screw locations.1. Remove the quick mount bracket from the fixture base byloosening the two set screws. See Figure 1. Properly discard thequick mount bracket.2. For attachment of box to mounting surface, drill (2) 9/32" (8mm)holes in opposite corners on the back surface of the surfacemounting box accessory (E-ACSBWFZ) for use with 1/4” (7mm)fasteners. Do NOT drill holes within 1/4” (7mm) of the edge on thesurface mounting box3. Attach surface mounting box to mounting surface using 1/4”(7mm) fasteners appropriate for mounting surface. Angled side ofsurface mounting box must be positioned facing up and down (onvertical axis of box). See Figure 2 on back page.NOTE: A high grade caulking material, such as a silicone rubber,should be used around perimeter of mounting box between backsurface of box and the mounting surface to ensure a watertightenclosure.MOUNTING OVER JUNCTION BOXFIGURE 1Fixture BaseQuick MountBracketSet ScrewsMOUNTING USING SURFACE CONDUIT (REQUIRESUSE OF E-ACSBWFZ ACCESSORY)