Danaher Motion S20630-SRS manuals
S20630-SRS
Table of contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- S200 Series Drives
- Model Number
- Before You Begin
- Specifications
- AC Input Drives - Control and Power
- AC Power On Delay
- Current Loop Bandwidth
- Command I/O
- Quadrature Input
- Mechanical
- Velocity Signal
- Quick Start Guides
- Hardware Setup
- Motor Feedback Configuration
- S200 Tools Communication Wizard
- SynqNet Configuration
- Save Options
- Mounting the Drive
- Mechanical Outline Drawings
- Base AC Drive (S21260-VTS)
- Base AC Drive (S22460-VTS)
- Base DC Drive (S20330-, S20630-VTS)
- SynqNet AC Drive (S20260-, S20360-, S20660-SRS)
- SynqNet DC Drive (S20330-, S20630-SRS)
- Wiring the Drive
- AC Drive (S21260-, S22460-VTS)
- j1 – ac input drive power
- DC Input Drive Wiring
- j1 – dc input drive power
- DC Power Supply Requirements
- Control Voltage
- j2 – motor power connector
- j3 – feedback connector
- General Purpose Inputs
- General Purpose Outputs
- High Speed Input
- SFD BAT
- Encoder Outputs/Inputs
- Analog Command Input
- j5 – serial port connector
- Serial Interface Specification
- SynqNet Option Card Wiring
- SynqNet LEDs
- j13 – discrete i/o connector
- j13 – discrete i/o connection schematic
- Auxiliary Feedback Device Port
- Auxiliary Feedback Sin-Cos Interpolation Scaling
- Basic Configuration
- S1 - Rotary Setup Switch
- S11, S12 - Rotary SynqNet ID Switches
- Configuring for Brush Motors
- Configuring with 6-Step (Hall) Feedback
- Step Velocity Mode
- Configuring with SFD Feedback
- SFD Torque/Current Mode
- SFD Velocity Mode
- SFD Position Mode
- Reversing Motion Direction
- Advanced Configuration
- Base Drive Torque/Velocity Control Block Diagram
- Base Drive Position Control Block Diagram
- SynqNet Drive Torque Control Block Diagram
- SynqNet Drive Velocity Control Block Diagram
- Parameters and Variables
- Read/Write NV Parameters
- Status And Control Variables
- Drive Monitor
- Monitoring Real-time Data from Drive
- Memory Operations on Drive Parameters
- Accessories, Connector Kits, and Cables
- Diagnostics and Troubleshooting
- Diagnostics
- Fault Generation
- A.1 Design
- A.1.2 Main Supply Output Capacitance (J1-3 to J1-2)
- A.2 Two Power Supply Operation
- A.2.1 Control Supply (J1-1 to J1-2)
- A.4.1 Min. External Bus Capacitance
- B.1 Long Cables
- D.1 Detailed Drive Motor Wiring Discovery Procedure
- F.1 S2xx50 AC Line Voltage Doubling Drive Power Specifications
- G.1 Conformance Requirements
- G.2.1. CE Test Setup
- G.2.3 Declaration of Conformity
- ce declaration of conformity
- G.3 Installation and Commissioning
- G.6 Low Voltage Directive and EN50178
- G.7 UL and cUL Conformance
- G.8 Additional Safety Precautions
- G.9 EMC Compliance with EN61800-3
- G.10 AC Mains Conducted Emissions
- G.11 Regen Resistor
manualsdatabase
Your AI-powered manual search engine