Danaher Motion 05/2008 Wiring the DriveS200-VTS Product Manual 576.8 J5 – Serial Port ConnectorJ5 a 6-pin RJ-12/RJ-11 connector provides RS-232 serial communication to the drive. The RS-232 transceiver is an industry standard RS-232 configuration using the MAX3221.1 6(J5 Connector view fromfront of drive)Pin DescriptionJ5-1 No ConnectionJ5-2 RX232J5-3 I/O RTNJ5-4 I/O RTNJ5-5 TX232J5-6 No ConnectionMating Connector InformationRJ12/RJ11 – Phone Style -Standard RJ12/RJ11 plugJ5-1, J5-6No ConnectionThese terminals are not used or connected to the drive.J5-2RX232RS-232 receiver input to the drive. This terminal connects to the user'sRS-232 transmitter output.J5-3, J5-4I/O RTNThese terminals are the common/ground connection for the RS-232serial port. The ground from the user's RS-232 needs to connect to thisterminal. Cable shielding is also connected to this point.J5-5TX232RS-232 Transmitter output from the drive. This terminal connects to theuser's RS-232 receiver input.CAUTIONDo NOT use the serial connector/cable when using an S200SynqNet Series Drive. SynqNet cables, not a serial cable, shouldbe used for communication between the drive and SynqNetmotion controller. If you connect to an S200 SynqNet Series Driveusing a serial cable and select 'Serial' instead of 'SynqNet' as theCommunications Mode in the S200Tools Communication Wizard,the drive will appear configured in the interface, but the SynqNetOptions tab will not appear under the Drive Setup options.
