Mounting the Drive 05/2008 Danaher Motion28 S200-VTS Product Manual5 MOUNTING THE DRIVEThe S200 drives are designed for operation in a cabinet using the following installationinstructions:Mount the drives vertically inside a cabinet on a flat, solid, electrically conductive mountingsurface that is connected to PE (Protective Earth Ground) and capable of supporting the weightof the unit.Provide a good connection to PE. Remove the paint on the mounting surface over an areaextending at least 12 mm (0.5 in) from the mounting bolts to achieve good electrical connectionover a large area between the drive and grounded mounting surface.Ensure that the environment within the cabinet meets the requirements listed in theSpecifications.5.1 Mounting DimensionsAC INPUT DRIVES DC INPUT DRIVESAC1AC2 AC3 AC4 AC5 DC BaseDrivew/OptionS20260S20360 S20660 S21260 S22448S20330-VTSS20630-VTSS20330-xS20630-xDrive DimensionsDrive Height (A) 175.0 mm6.90 in177 mm6.97 in213 mm8.39 in152.4 mm6.00 inDrive Width (B) 54.8 mm2.16 in64.0 mm2.52 in76 mm3.00 in96.4 mm3.80 in28.7 mm1.13 in48.3 mm1.90 inDrive Depth1 (C) 131.6 mm5.18 in152 mm5.98 in192 mm7.57 in100.8 mm3.97 inClearance RequirementsTop and Bottom(D)12.7 mm0.50 in12.7 mm0.50 in12.7 mm0.50 in19 mm0.75 in12.7 mm0.50 in12.7 mm0.50 inSide to Side (E) 12.7 mm0.50 in12.7 mm0.50 in12.7 mm0.50 in19 mm0.75 in12.7 mm0.50 in12.7 mm0.50 inMounting DimensionsHorizontalMounting Offset(F)25.6 mm1.01 in25.6 mm1.01 in31.7 mm1.25 in57.5 mm& 6.5mm24.6 mm0.97 in24.6 mm0.97 inVertical MountingOffset (G)4.3 mm0.17 in4.3 mm0.17 in2.1 mm0.08 in5.0 mm0.20 in4.1 mm0.16 in4.1 mm0.16 inVertical MountingHeight (H)166.4mm6.55 in166.4mm 6.55in169.5mm 6.67in202.5mm 7.97in144.3mm5.68 in144.3mm5.68 inDrive to DriveMounting (J)67.5 mm2.66 in76.7 mm3.02 in88.7 mm3.39 in115.4mm 4.54in41.40mm1.63 in60.96mm2.40 inMountingHardware M4 or #8 M4 or #8 M4 or #8 M4 or #8 M4 or #8 M4 or #8Drive Weight(no option card)0.77 kg1.69 lb0.85 kg1.86 lb1.33 kg2.93 lb2.56 kg5.64 lb0.40 kg0.88 lb0.5 kg1.10 lb1 Depth measurement is for drive only. Add approximately 50.8 mm (2 in) to depthgiven in the table to accommodate mating connectors and wire bend radius.
