Eaton Sefelec XS series manuals
Sefelec XS series
Table of contents
- This manual is written for the following XS series models
- WARRANTY
- Restrictions due to the accessories or the options
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Specifications
- DIELECTRIC STRENGTH TEST 50VA
- Maximum current limit : IMAX
- Permanent current measurement
- µA current resolution (OPTION 116-00)
- Output voltage
- DIELECTRIC STRENGTH TEST 10VA
- Detection of capacitive samples
- Megohmmeter function (insulation resistance measurement)
- Measurement threshold
- V megohmmeter function (option XS26 or MXS1000)
- Measurement accuracy
- Timer
- Ground continuity function
- Measurement thresholds
- MEANING OF THE DIFFERENT SYMBOLS ON THE INSTRUMENT
- PRODUCT OVERVIEW
- Front panel description
- Liquid Crystal Display (LCD) description
- Rear panel description
- Available accessories and options
- Installation
- Power ON
- Connection to a specimen
- Unit configuration
- Beep on FAIL configuration
- Access control to the parameters
- Measurement display
- Remote trigger mode
- Interface selection
- EXPERT mode Activation
- Insulation resistance measurement
- Measurement threshold selection
- Timer operation
- Parameter memorization
- Error messages
- Dielectric strength test (hipot test)
- Test voltage selection
- Test voltage application on the specimen
- To set the RISE and FALL times
- Breakdown detection mode selection
- Maximum current and variation current limit : IMAX + I
- IMIN and IMAX threshold adjustment
- Delta I level adjustment
- Activation of the capacitive sample detection
- Expert mode parameters only
- IMAX and delta I thresholds adjustment during the ramps
- Configuration of the minimum capacity value to detect
- Dielectric strength test error messages
- Ground continuity resistance measurement
- Measurement current selection
- Resistance threshold selection
- Ground continuity measurement error messages
- Sequence mode operation (SXS)
- Function selection
- Parameter memory number selection
- How to run a simple sequence
- Sequence with manual control
- Multiple ground continuity operation
- Multiple ground continuity followed by a dielectric strength test ( automatic sequence)
- Error messages for the Sequence mode
- Accessories with remote control feature
- Operation
- Specific case for the sequence (SXS50 & 500)
- Input output Interfaces
- Connections
- Description of the input output signals
- Measurement discharge cycle
- Information on cycle timing
- PLC > RS Interface (Option 115-00)
- Volts analog input output (03 OPTION )
- Change of the board setup
- Megohmmeter mode, 2 outputs setup
- Dielectric strength test mode, 2 outputs setup
- Operating instructions
- IEEE-488 interface
- Commands
- ETHERNET Interface
- How to set the Ethernet interface card under Windows XP
- Configuring the connexion on the unit
- Protocol and communication port
- List of the ETHERNET commands
- Error message(s)
- RS232C interface
- Syntax rules
- List of the RS232C commands
- Advices and programming examples
- Trouble shooting the RS232 interface
- APPLICATION NOTES
- Environmental influences
- Precautions to be observed
- Measurements on cables
- Dielectric strength tests
- Ground continuity measurement
- Safety interlock connector (C5)
- Measurement I/O on the rear panel
- Maintenance and calibration
- CLEANING
- Annexes
- wires option for XS series and hipot function
- Operation of the XS 4-wire option in XS hipot function
- Schematic diagram of the option
- Uses cases
- HV sensor connection recommendations
- Rear view of the unit and accessory connections
- Nominal DC currents in the hipot function
- XS 500VA DC current curves (RXS506, DXS506, SXS506)
manualsdatabase
Your AI-powered manual search engine