Eaton Sefelec RXS50 Operating Manual

Contents

XS series operating manualXS user manual v0.55 - 107 -Dielectric strength test mode, 2 outputs setupRefer to section related to the board jumpers setup. This setup is the factory default setup.The pin 2 of the rear panel connector gives the value of the measured high voltage (V1) : from 0 to 10 volts for 0 to 5000 VAC from 0 to 10 volts for 0 to 6000 VDCThe pin 1 of the rear connector gives the value of the leakage current (V2) : from 0 to 10 for 0.00mA to 9.99 mATest voltages and leakage current are given by the following formulas:HTVAC = (V1/10) x 5000 voltsHTVDC = (V1/10) x 6000 voltsI = (V2/10) x Imax.Imax = 9.99mA for SXS, DXS and RXS50Imax = 99.9mA for SXS, DXS and RXS500Accuracy of the 0-10 volts output voltage compared to the display : ±(0.1% + 5 mV)Dielectric strength test mode, 1 output + 1 input setupRefer to section related to the board jumpers setup.This setup is operating only in the MANUAL mode Select HIPOT function Select PARAM On , on the line TIMER : select the MANUAL modeThe pin 2 of the rear panel connector gives the value of the measured high voltage (V1) : from 0 to 10 volts for 0 to 5000 VAC from 0 to 10 volts for 0 to 6000 VDCTest voltages are given by the following formulas:HTVAC = (V1/10) x 5000 voltsHTVDC = (V1/10) x 6000 voltsAccuracy of the 0-10 volts output voltage compared to the display : ±(0.1% + 5 mV)The pin 1 of the rear panel connector is an input which can receive voltages between 0and 10 VDC for output high voltages from 0 to the maximum value displayed on the parameterline:VOLTAGE:x.xx VAC.If the input voltage is higher than 10 V +5%, the following message is displayed :[LIMIT ERROR]Accuracy of the output high voltage compared to the input voltage :±(1% + 20 volts) for a leakage current < 100uAThere is no automatic adjustment of the output voltage according to the load.