Monitoring 69used to detect if a new device is plugged into aswitch port. (Default: Disabled)■ Max Count – The maximum number of hosts thatcan connect to a port when the Multi-Hostoperation mode is selected. (Range: 1-1024;Default: 5)■ Reauthentication Period – Sets the time period afterwhich a connected client must be re-authenticated.(Range: 1-65535 seconds; Default: 3600 seconds)■ Quiet Period – Sets the time that a switch port waitsafter the Max Request Count has been exceededbefore attempting to acquire a new client. (Range:1-65535 seconds; Default: 60 seconds)■ Transmit Period – Sets the time period during anauthentication session that the switch waits beforere-transmitting an EAP packet. (Range: 1-65535;Default: 30 seconds)After you have filled in the parameters, click Apply tosave your changes.Figure 64 802.1X Setup ScreenMonitoringUsing the Web interface, you can display address tableinformation, set up port mirroring, and perform cablediagnostics.The Monitoring menu includes three items:■ Address Table■ Port Mirroring■ Cable DiagnosticsAddress TableThe Switch’s address table contains the MAC addresseslearned by monitoring the source address for traffic