CLI Commands 97InitializeThe Initialize command resets the device configurationto factory defaults, retaining the current IPconfiguration.SyntaxInitializeDefault ConfigurationThis command has no default configuration.User GuidelinesThe system prompts for confirmation of the request. Ifno response is entered within 15 seconds, timeoutoccurs and the command is not executed.ExampleThe following example resets the Switch to factorydefaults:RebootThe Reboot command simulates a power cycle of thedevice.SyntaxrebootDefault ConfigurationThis command has no default configuration.User GuidelinesThere are no user guidelines for this command.ExampleSelect menu option: initializeWARNING: This command initializes the system tofactory defaults (excluding Management IPconfiguration) and causes a reset.Do you wish to continue (yes,no)[no]: yesSaving configuration.....Saved config to allunits.System rebooting..........Select menu option: rebootAre you sure you want to reset the system(yes,no)[no]: yesSaving configuration......Saved config to allunits.System rebooting..........