CLI Commands 95ipSetupThe ipSetup command allows the user to define an IPaddress on the device either manually or via a DHCPserver.SyntaxipSetupDefault ConfigurationNo default IP address is defined for interfaces.User GuidelinesWhen the IP address is configured manually by the user,the address must be in the range 0.0.0.0 through223.255.255.255.IP Addresses configured beyond the range of 224.0.0.0are defined as multicast, experimental or broadcastaddresses.If a default gateway is configured manually, theIP-address and mask are required to be the same as thegateway-address and mask.ExampleThe following example displays an IP address configuredmanually:The following example displays an IP address obtainedvia a DHCP server:Select menu option: ipSetupEnter configuration method (auto,manual)[auto]:manualEnter IP Address [0.0.0.0 ]:192.168.1.1Enter Subnet Mask [255.255.0.0 ]:255.255.255.0Enter Default Gateway [192.168.1.254 ]:Select management VLAN ID (1)[1]:This operation may take up to 30 seconds.Select menu option:Select menu option: ipSetupEnter configuration method (auto,manual)[manual]:autoSelect management VLAN ID (1)[1]:This operation may take up to 30 seconds.Select menu option:
