5 NETWORK P ROTOCOLIP AddressConfigurationCommandsdisplay ip interface Syntaxdisplay ip interface { interface-type interface-number | interface-name }ViewAny viewParameterinterface-type: Interface type.interface-number: Interface sequence number.interface-name: Interface name.DescriptionUsing the display ip interface command, you can display the running condition ofall the interfaces.Example3Com<3Com> display ip interface Ethernet6/0/0Ethernet6/0/0 current state : UPLine protocol current state : UPInternet Address : 5.5.5.5/8Broadcast address : 0.0.0.0The Maximum Transmit Unit : 1500 bytesinput packets : 1231, bytes : 57557, multicasts : 1177output packets : 0, bytes : 0, multicasts : 0The following information is displayed: the current physical link state of Ethernet6/0/0 is UP, the protocol of link layer is UP, the IP address is 5.5.5.5, the broadcastaddress is 0.0.0.0, the maximum transmit unit is 1500 bytes and some otherinformation about packets receiving/sending via this interface.ip address Syntaxip address ip-address net-mask [ sub ]
