SVC MPLS L2VPN Configuration Commands 807DescriptionUsing the static-lsp transit command, you can configure a static LSP used in L2VPNfor transit LSR. Using the undo static-lsp transit command, you can delete an LSPused in L2VPN of transit LSR.Two LSPs (one in each direction) should be created in advance and configured tothe transit LSR before creating remote CCC connection.For related commands, see static-lsp egress l2vpn and static-lsp ingress l2vpn.ExampleAdd a static LSP used in 12vpn for the Serial0/0/0 of transit LSR, with inboundlabel being 123 and outbound label being 253.[3Com-mpls] static-lsp transit bj-sh l2vpn incoming-interfaceserial0/0/0 in-label 123 nexthop 202.34.114.7 out-label 253SVC MPLS L2VPNConfigurationCommandsdisplay mpls static-l2vc Syntaxdisplay mpls static-l2vc [ interface interface-type interface -num ]ViewAny viewParameterinterface-type interface -num: Interface type and interface numberDescriptionUsing the display mpls static-l2vc command, you can view the connectioninformation of static MPLS L2VPN.ExampleDisplay basic information of static connection.[3Com-Ethernet1/0/1] display mpls static-l2vctotal connections: 1, 0 up, 1 downce-intf state destination tr-label rcv-label tnl-typetnl-indexEthernet1/0/1 down 192.1.1.1 222 111 --0[3Com] display mpls static-l2vc interface ethernet1/0/1CE-interface: Ethernet1/0/1 is up, VC State: down, Destination:192.1.1.1,transmit-vpn-label: 222, receive-vpn-label: 111,tunnel type: --, tunnel index: 0
