Remote-ping Configuration 467The remote-ping test does not display test results. You can use the displayremote-ping command to view the test results.You can use the display remote-ping command to check the test history as well as thelatest test results.Configuration Example Network RequirementPerform an remote-ping ICMP test between two switches. Like a ping test, this testuses ICMP to test the RTTs of data packets between the source and the destination.Configuration procedure1 Enable remote-ping Client.[S5500] remote-ping-agent enable2 Create an remote-ping test group administrator icmp.[S5500] remote-ping administrator icmp3 Configure the test parameters.[S5500-remote-ping-administrator-icmp] test-type icmp[S5500-remote-ping-administrator-icmp] destination-ip 10.10.10.10[S5500-remote-ping-administrator-icmp] count 10[S5500-remote-ping-administrator-icmp] timeout 34 Enable the test operation.[S5500-remote-ping-administrator-icmp] test-enableConfigure the testparametersConfigurethedestination IPaddress ofthe testdestination-ip ip-address RequiredBy default, no destination IPaddress is configured.Configurethe type ofthe test.test-type type OptionalBy default, the test type isICMP.Configurethe packetsendingtimes in eachtest.count times OptionalBy default, the packet sendingtimes in each test is 1.Configuretheautomatictest interval.frequency interval OptionalBy default, the automatic testinterval is zero, whichindicating the test will beperformed only once.Configurethe timeouttime of thetest.timeout time OptionalBy default, the timeout time is3 seconds.Execute the test test-enable RequiredDisplay test results display remote-ping { history| results } [administrator-name test-tag ]RequiredYou can execute the commandin any view.Table 519 Configure Remote-ping (continued)Operation Command Description
