Installation ManualH3C S7500 Series Ethernet Switches Chapter 5 System Commissioning5-1Chapter 5 System Commissioning5.1 Configuration Environment Setup5.1.1 Setting up Networking Environmentz The terminal (a PC in this example) is connected to the console port of the switchwith a console cable.Console cablePCSwitchConnect to the serialportConnect to theConsole portFigure 5-1 Network diagram for switch configuration5.1.2 Connecting the Console CableFollow these steps to connect the console cable:1) Connect the DB-9 female connector of the console cable to the serial port of thePC.2) Connect the RJ-45 connector of the console cable to the console port of theswitch.5.1.3 Setting Terminal ParametersParameter requirements:z Bits per second: 9600z Data bits: 8z Parity check: None.z Stop bits: 1.z Flow control: None.z Terminal emulation: VT100.The following illustrates how to set terminal parameters on the PC running Windows XPHyperTerminal.Step 1: Start the PC and run the terminal emulator.
