Installation ManualH3C S7500 Series Ethernet Switches Chapter 4 Hardware Installation4-3Figure 4-2 Mount the S7506 in an N68 cabinetI. Installing an N68 cabinetIn an N68 cabinet ready for delivery, a place has been arranged for mounting the switchaccording to the order, and all accessories outside the switch, except for the LPUs andcables, have been installed. For the procedure for installing an N68 cabinet, refer toAppendix B.II. Mounting the switch1) Before installation, make sure that:z The N68 cabinet has been fixed and a place has been arranged for the switch,without any obstacle in or around the cabinet.z The switch is ready for installation and has been carried to a place near thecabinet.2) Mount a plate in the N68 cabinet to hold the switch.3) Install the supplied cable management bracket and mounting bracket on theswitch.4) Carry the switch with another person to the front of the cabinet.5) Lift the switch a little higher than the plate, put it on the plate and adjust its location.6) Attach the mounting bracket to the square holes in the brackets of the N68 cabinetwith screws to fix the switch on the cabinet.4.3.2 Mounting the Switch on a Table1) Before installation, make sure that:z The table is firm enough to hold the switch and cables.z There are no obstacles around the table.
