Installation ManualH3C S7500 Series Ethernet Switches Chapter 7 Software Maintenance7-106) Type Y to start file downloading or N to return to the BootROM update menu. If youtype Y and press Enter, the system starts program downloading. After theprogram is downloaded, the system writes the program to the Flash memory. Theterminal displays the following information after the write operation:Prepare for loading...OK!Loading....................................................done!SRPG bootrom is updating now......Get flash Type......FLASH_M29W040BErasing flash......done!Programming flash......done!Checking flash......done!III. Loading host softwareFollow these steps to load the host software of the switch:1) Select 1 from the Boot Menu. The terminal displays the following information:1. Set TFTP protocol parameter2. Set FTP protocol parameter3. Set XMODEM protocol parameter0. Return to boot menuEnter your choice(0-3):3You can select different protocols to load the host software.The subsequent steps are the same as those for loading a Boot ROM, except for theprompt information.7.2.4 Loading Software from the Management Ethernet Port Using FTPI. Introduction to FTPThrough the management Ethernet port, the switch can act as an FTP server or clientto provide another approach to software loading and file configuration.In the following example, the switch functions as an FTP client.II. Loading a Boot ROMFollow these steps to load a Boot ROM:1) Connect the management Ethernet port of the switch to the PC, from which theBoot ROM program is to be downloaded (the IP address of the PC is required).Connect the console port to the same PC or another one.2) Run the FTP Server program on the PC connected to the Ethernet port, specifythe file directory of the program to be downloaded, and set a login username andpassword.
