128 CHAPTER 4: CONFIGURING PATH BUILDER S330/S310 MODULES , PORTS , AND APPLICATIONSDial Timer—The amount of time, in seconds, after which dialing is assumed to beended if no further digits have been received: 6-60. This parameter applies to thevideo dial feature. The RS-366 specification does not require all calls to be endedwith the EON (End of Number) digit. If no EON is available, the CBR software usesthe Dial Timer to determine when dialing is complete. The CBR software resets thetimer each time a digit is received. When the timer expires, the dialing is assumedto be completed, and the RS-366 driver forwards the call to the call handling taskfor further processing.When used alone, the CBR V.35 interface is used in the lease line environment,and all of the interface signals are forced to on. When used with RS-366, the CBRV.35 interface is used in a switched environment. The DSR and CTS&DCD optionsallow you to emulate the switched environment by specifying that certaininterface signals should go off in alarm conditions.DSR Option—Specifies the behavior of the DSR interface signal:Forced On—Force the DSR signal to on in all conditions.Follow DTR—Direct the DSR signal to follow the DTR signal.Toggle—Toggle the DSR signal off for three seconds and then to on after theDSC goes off.CTS&DCD Option—Specifies the behavior of the CTS and DCD interface signals:Forced On—Force the CTS and DCD signals to on in all conditions.Follow DTR—Direct the CTS and DCD signals to follow the DTR signal.Follow DTR & DSC—Direct the CTS and DCD signals to follow the DTR andDSC signals.Admin. Status—Administrative status: In Service or Out of Service.Configuring the CBRCardThe only type of configuration you can perform on the T1/E1 UNI card is to put itin service or out of service.To put the T1/E1 UNI card in service or out of service, follow these steps:1 From the Configuration Management menu, select [1] Manage Card.2 From the List Card menu, shown earlier in Figure 51, select [7] CBR. The CBRT1-DSX or CBR E1 Configuration Selection menu appears, as shown earlier inFigure 93.3 Select [5] Card Configuration to display the CBR Card Configuration menu.Figure 98 shows the CBR E1 Card Configuration menu. The CBR t1-DSX CardConfiguration menu is the same.
