Managing the Video Dial Feature 161Managing Video Dial-upSessionsTo set up, activate, and end a video dial-up session, follow these basic steps:1 Create virtual circuits between the appropriate PathBuilder S330/S310 units. Thiseffectively builds a call routing table.For detailed instructions, see“Defining RS366 (Video) Virtual Circuit Templates”,earlier in this chapter.2 Start the session either manually or automatically via the RS-366 interface. Fordetails, see “Starting Video Dial-up Sessions” later in this section.3 End the session either manually or automatically via the V.35 interface. For details,see “Ending Video Dial-up Sessions” later in this section.Starting Video Dial-up SessionsA video dial-up session starts (connects) automatically when someone dials anumber matching one of the numbers in the call routing table (one of thenumbers associated with an RS366 virtual circuit template) on a video keypad. Youcreate the call routing table by building virtual circuits between PathBuilderS330/310 CBR modules. For details about building video virtual circuits, see“Defining RS366 (Video) Virtual Circuit Templates”, earlier in this chapter. Fordetails about viewing the call routing table, see “Viewing the Video Call RoutingTable” later in this section.You can also start (connect) a video dial-up session manually. To do this, followthese steps:1 From the Configuration Management menu, select [4] Manage Video Dial todisplay the Manage Video Dial menu, shown earlier in Figure 129.2 From the Manage Video Dial menu, select [2] Manually Connect (Dial) A Site todisplay the Manually Connect A Site menu, shown in Figure 130. The currentconnection status is displayed at the top of the menu.Figure 130 Manually Connect A Site Menu
