80 CHAPTER 4: CONFIGURING PATH BUILDER S330/S310 MODULES , PORTS , AND APPLICATIONSUpdating the Flash FileSystemThe flash file system contains system configuration information which isautomatically saved in flash memory at a predetermined interval. To update theflash file system immediately, rather than at the next scheduled interval, followthese steps:1 From the System Administration menu, select [8] Update Flash File System. Thefollowing prompt appears:Do you want to update the flash file system (Y/N) [N]?2 Enter y to update the flash file system.CAUTION: The user configuration data is automatically saved into flash memoryevery minute. If there is a system failure (for example. a power failure), anychanges that you make during the auto-saving interval will be lost. Thus, werecommend that you use the [8] Update Flash File System option, as describedabove, immediately after you make major configuration changes.Resetting the InterfaceCardThe PathBuilder S330/S310 software allows you to reset only the MCPU interfacecard and the Voice Compression module (VCM) card. Resetting the MCPU rebootsthe system. To reset the MCPU interface card or the VCM card, follow these steps:If you reset the MCPU interface card, you will terminate your Telnet session.1 From the System Administration menu, select [9] Reset Interface Card. You areprompted to select the card you want to reset.2 Enter the option corresponding to the card you want to reset (MCPU or VCM). Thefollowing prompt appears:Are you sure you want to reset this card (Y/N) [N]?3 Enter y to reset the selected card.Viewing an EquipmentListTo view information about the modules currently installed on your PathBuilderS330/S310:From the System Administration menu, select [10] Show Equipment List. Figure 49shows a representative Equipment List.Figure 49 Equipment List
