Displaying and Maintaining Information Center 1015■ In the interaction mode, you are prompted for some information input. If theinput is interrupted by system output, no system prompt will be made, ratheronly your input will be displayed in a new line.Displaying andMaintainingInformation CenterInformation CenterConfigurationExamplesOutputting LogInformation to a UnixLog HostNetwork requirements■ Send log information to a Unix log host with an IP address of 1.2.0.1/16;■ Log information with severity higher than informational will be output to thelog host;■ The source modules are ARP and IP.Network diagramFigure 302 Network diagram for outputting log information to a Unix log hostConfiguration procedureBefore the configuration, make sure that there is a route between Device and PC.1 Configuring the device# Enable information center. system-view[Sysname] info-center enableTo do… Use the command… RemarksDisplay channelinformation for a specifiedchanneldisplay channel [ channel-number |channel-name ]Available in any viewDisplay the configurationson each output destinationdisplay info-center Available in any viewDisplay the state of the logbuffer and the loginformation recordeddisplay logbuffer [ level severity |size buffersize ] * [ | { begin | exclude| include } text ]Available in any viewDisplay a summary of thelog bufferdisplay logbuffer summary [ levelseverity ]Available in any viewDisplay the state of thetrap buffer and the trapinformation recordeddisplay trapbuffer [ size buffersize ] Available in any viewReset the log buffer reset logbuffer Available in user viewReset the trap buffer reset trapbuffer Available in user viewInternetDevice PC1.1.0.1 /16 1 .2.0.1/16
