922 CHAPTER 73: CLUSTER M ANAGEMENT CONFIGURATIONDisplaying andMaintaining ClusterManagementn ■ Support for the display ntdp single-device mac-address command varieswith devices.■ When you display the cluster topology information, the devices attached to theswitch that is listed in the blacklist will not be displayed.Cluster ManagementConfigurationExamplesCluster ManagementConfiguration ExampleOneNetwork requirementsThree switches form a cluster, in which:■ One device serves as the management device.■ The other two are the member devices.The specific requirements are as follows:■ The management device is connected to the external network through itsEthernet 1/1 port. The two member devices are connected to Ethernet 1/2 andEthernet 1/3 ports of the management device.To do… Use the command… RemarksDisplay NDP configurationinformationdisplay ndp [ interface interface-list ] Available in anyviewDisplay the global NTDPinformationdisplay ntdpDisplay the deviceinformation collected throughNTDPdisplay ntdp device-list [ verbose ]Display the detailed NTDPinformation of a specifieddevicedisplay ntdp single-device mac-addressmac-addressView cluster state andstatisticsdisplay clusterView the standard topologyinformationdisplay cluster base-topology[ mac-address mac-address | member-idmember-number ]View the current blacklist ofthe clusterdisplay cluster black-listView the information ofcandidate devicesdisplay cluster candidates[ mac-address mac-address | verbose ]Display the current topologyinformation or the topologypath between two devicesdisplay cluster current-topology[ mac-address mac-address[ to-mac-address mac-address ] |member-id member-number[ to-member-id member-number ] ]Display members in a cluster display cluster members[ member-number | verbose ]Clear NDP statistics reset ndp statistics [ interfaceinterface-list ]Available in userview
