3Com VCX V7122 SIP VoIP Gateway User Manual 101SNMP ParametersTable 25 SNMP Parameterini File Field NameWeb Parameter Name* Valid Range and DescriptionDisableSNMP[Enable SNMP]0 = SNMP is enabled (default).1 = SNMP is disabled and no traps are sent.SNMPPort The device’s local UDP port used for SNMP Get/Set commands.The range is 100 to 3999.The default port is 161.SNMPTrustedMGR_x Up to five IP addresses of remote trusted SNMP managers from which theSNMP agent accepts and processes get and set requests.Note 1: If no values are assigned to these parameters any manager can accessthe device.Note 2: Trusted managers can work with all community strings.SNMP Trap ParametersSNMPManagerTableIP_x[SNMP Managers Table]Up to five IP addresses of remote hosts that are used as SNMP Managers. Thedevice sends SNMP traps to these IP addresses.Enter the IP address in dotted format notation, for example 108.10.1.255.Note: The first entry (out of the five) replaces the obsolete parameterSNMPManagerIP.SNMPManagerTrapPort_x[SNMP Managers Table]Up to five parameters used to define the Port numbers of the remote SNMPManagers. The device sends SNMP traps to these ports.Note: The first entry (out of the five) replaces the obsolete parameterSNMPTrapPort.The default SNMP trap port is 162.The SNMP trap port must be between 100 to 4000.SNMPManagerIsUsed_x[SNMP Managers Table]Up to five parameters, each determines the validity of the parameters (IPaddress and port number) of the corresponding SNMP Manager used to receiveSNMP traps.0 = Disabled (default)1 = EnabledSNMPManagerTrapSendingEnable_x[SNMP Managers Table]Up to five parameters, each determines the activation/deactivation of sendingtraps to the corresponding SNMP Manager.0 = Sending is disabled1 = Sending is enabled (default)SNMPManagerIPNote: Obsolete parameter, useSNMPManagerTableIP_x instead.IP address (in dotted format notation) for the computer that is used as the firstSNMP Manager. The SNMP Manager is a device that is used for receivingSNMP Traps.Note 1: To enable the device to send SNMP Traps, set the ini file parameterSNMPManagerIsUsed to 1.Note 2: If you want to use more than one SNMP manger, ignore this parameterand use the parameters ‘SNMPManagerTableIP_x’ instead.In Table 25, parameters in brackets are the format in the Embedded WebServer *.
