3Com VCX V7122 SIP VoIP Gateway User Manual 37Restoring Networking Parameters to Their Initial StateYou can use the ‘Reset’ button to restore the VCX V7122 networking parameters to theirfactory default values (described in Table 14 on page 35) and to reset the username andpassword.Note that this process also restores the VCX V7122 parameters to their factory settings,therefore you must load your previously backed-up ini file, or the default ini file (received withthe software kit) to set them to their correct values.This option is currently supported on one media gateway module (trunks 1-8) only.To restore networking parameters to their initial state, follow these steps:1 Disconnect the VCX V7122 from the power and network cables.2 Reconnect the power cable; the gateway is powered up. After approximately 45 seconds,the ACT LED blinks for about 4 seconds.3 While the ACT LED is blinking, press shortly on the reset button (located on the frontpanel); the gateway resets a second time and is restored with factory default parameters(username: “Admin”, password: “Admin”).4 Reconnect the network cable.5 Load your previously backed-up ini file, or the default ini file (received with the softwarekit). To load the ini file via the Embedded Web Server, see Restoring and Backing Up theGateway Configuration on page 72.Configuring the VCX V7122 Basic ParametersTo configure the VCX V7122 basic parameters use the Embedded Web Server’s ‘QuickSetup’ screen (see Figure 15 below). See Accessing the Embedded Web Server on page 42for information on accessing the ‘Quick Setup’ screen.
