330 CHAPTER 11: MANAGED ACCESS P OINT COMMANDSset {ap | dap} blink Enables or disables LED blink mode on a MAP access point to make iteasy to identify.When blink mode is enabled on an AP2750, the 11a LED blinks on andoff.When blink mode is enabled on an AP7250, the Radio LED flashes redand the Power LED flashes green/orange. The Ethernet LED does notchange.When blink mode is enabled on an AP8250, the Radio LED flashes redand the Power LED flashes green/orange. The Ethernet LED does notchange.When blink mode is enabled on an AP8750, both Radio LEDs flash redand the Power LED flashes green/orange. The Ethernet LED does notchange.When blink mode is enabled on other models (MP-xxx), the health andradio LEDs alternately blink green and amber. By default, blink mode isdisabled.Syntax — set {ap port-list | dap dap-num | auto}blink {enable | disable} ap port-list — List of ports connected to the MAP access points onwhich to turn blink mode on or off. dap dap-num — Number of a Distributed MAP on which to turn blinkmode on or off. dap auto — Configures blink mode for the MAP configurationprofile. (See set dap auto on page 325.) enable — Enables blink mode. disable — Disables blink mode.Defaults — LED blink mode is disabled by default.Access — Enabled.History —Introduced in MSS Version 3.0. Option auto added forconfiguration of the MAP configuration profile.
