336 CHAPTER 11: MANAGED ACCESS P OINT COMMANDS dap auto — Sets the maximum power for radios configured by theMAP configuration profile. (See set dap auto on page 325.) radio 1 — Radio 1 of the MAP. radio 2 — Radio 2 of the MAP. (This option does not apply tosingle-radio models.) power-level — Maximum power setting RF Auto-Tuning can assignto the radio, expressed as the number of decibels in relation to 1milliwatt (dBm). You can specify a value from 1 up to the maximumvalue allowed for the country of operation.The power-level can be a value from 1 to 20.Defaults — The default maximum power setting that RF Auto-Tuningcan set on a radio is the highest setting allowed for the country ofoperation or highest setting supported on the hardware, whichever islower.Access — Enabled.History —Introduced in MSS Version 3.0. Option auto added forconfiguration of the MAP configuration profile.Examples — The following command sets the maximum power thatRF Auto-Tuning can set on radio 1 on the MAP access point on port 6 to12 dBm.WX1200# set ap 6 radio 1 auto-tune max-power 12success: change accepted.See Also set {ap | dap} radio auto-tune max- retransmissions on page 337 set radio-profile auto-tune power-backoff- timer on page 352 set radio-profile auto-tune power-config on page 353 set radio-profile auto-tune power-interval on page 354
