56 Mechanical installation6. Remove the front cover: Remove the fastening screws (a), move the cover to thetop side (b) and then up (c).7. Attach the cable box to the drive frame.8. Tighten the box screws: two at the top and four at the bottom. Installing the drive vertically side by sideInstall the drive following the steps in the appropriate section Installing the drivevertically, frames R0…R4 (page 50), Installing the drive vertically, frame R5 (page 52)or Installing the drive vertically, frames R6…R9 (page 55). Installing the drive horizontallyInstall the drive following the steps in the appropriate section Installing the drivevertically, frames R0…R4 (page 50), Installing the drive vertically, frame R5 (page 52)or Installing the drive vertically, frames R6…R9 (page 55). The drive can be installedeither the left or right side up.Note: It is not allowed to install drives immediately on top of it each other.Flange mountingInstructions for flange mounting are delivered with the flange mounting kit: Flangemounting quick guide for frames R6 to R9 (3AXD50000019099 [English]). For moreinformation on flange mounting, see Flange mounting supplement(3AXD50000019100 [English]).6a788M8×66a6b6c
