110 Copyright © Acronis, Inc., 2000-2010Network connection speedThis option is effective for Windows and Linux operating systems and bootable media.This option is available when a location on the network (network share, managed vault or anFTP/SFTP server) is selected as the backup destination.The option defines the amount of network connection bandwidth allocated for transferring thebackup data.By default the speed is set to maximum, i.e. the software uses all the network bandwidth it can getwhen transferring the backup data. Use this option to reserve a part of the network bandwidth toother network activities.The preset is: Maximum.To set the network connection speed for backupDo any of the following: Click Transferring speed stated as a percentage of the estimated maximum speed of thenetwork connection, and then drag the slider or type a percentage in the box Click Transferring speed stated in kilobytes per second, and then enter the bandwidth limit fortransferring backup data in kilobytes per second.3.4.1.10 NotificationsAcronis Backup & Recovery 10 provides the ability of notifying users about backup completionthrough e-mail or the messaging service.E-mailThis option is effective for Windows and Linux operating systems.This option is not available when operating under the bootable media.The option enables you to receive e-mail notifications about the backup task's successful completion,failure or need for interaction along with the full log of the task.The preset is: Disabled.To configure e-mail notification1. Select the Send e-mail notifications check box to activate notifications.2. In the E-mail addresses field, type the e-mail address to which notifications will be sent. You canenter several addresses separated by semicolons.3. Under Send notifications, select the appropriate check boxes as follows: When backup completes successfully – to send a notification when the backup task hascompleted successfully When backup fails – to send a notification when the backup task has failedThe When user interaction is required check box is always selected.4. For the e-mail message to include the log entries related to the backup, select the Add full log tothe notification check box.5. Click Additional e-mail parameters, to configure additional e-mail parameters as follows, thenclick OK:
