43 Copyright © Acronis, Inc., 2000-2010The outdated backup will be kept until all backups that depend on it also become outdated. Thenall the chain will be deleted at once during the regular cleanup. This mode helps to avoid thepotentially time-consuming consolidation but requires extra space for storing backups whosedeletion is postponed. The archive size and/or the backup age can exceed the values you specify. Consolidate the backupThe program will consolidate the backup that is subject to deletion with the next dependentbackup. For example, the retention rules require to delete a full backup but retain the nextincremental one. The backups will be combined into a single full backup which will be dated theincremental backup date. When an incremental or differential backup from the middle of thechain is deleted, the resulting backup type will be incremental.This mode ensures that after each cleanup the archive size and the backups’ age are within thebounds you specify. The consolidation, however, may take a lot of time and system resources.And you still need some extra space in the vault for temporary files created during consolidation.What you need to know about consolidationPlease be aware that consolidation is just a method of deletion but not an alternative to deletion.The resulting backup will not contain data that was present in the deleted backup and wasabsent from the retained incremental or differential backup.Backups resulting from consolidation always have maximum compression. This means that allbackups in an archive may acquire the maximum compression as a result of repeated cleanupwith consolidation.Best practicesMaintain the balance between the storage device capacity, the restrictive parameters you set andthe cleanup frequency. The retention rules logic assumes that the storage device capacity is muchmore than the average backup size and the maximum archive size does not come close to thephysical storage capacity, but leaves a reasonable reserve. Due to this, exceeding the archive sizethat may occur between the cleanup task runs will not be critical for the business process. The rarerthe cleanup runs, the more space you need to store backups that outlive their lifetime.The Vaults (p. 130) page provides you with information about free space available in each vault.Check this page from time to time. If the free space (which in fact is the storage device free space)approaches zero, you might need to toughen the restrictions for some or all archives residing in thisvault.2.8 Backing up dynamic volumes (Windows)This section explains in brief how to back up and recover dynamic volumes (p. 405) using AcronisBackup & Recovery 10. Basic disks that use the GUID Partition Table (GPT) are also discussed.Dynamic volume is a volume located on dynamic disks (p. 404), or more exactly, on a disk group (p.403). Acronis Backup & Recovery 10 supports the following dynamic volume types/RAID levels: simple/spanned striped (RAID 0) mirrored (RAID 1) a mirror of stripes (RAID 0+1) RAID 5.Acronis Backup & Recovery 10 can back up and recover dynamic volumes and, with minor limitations,basic GPT volumes.
