231 Copyright © Acronis, Inc., 2000-2010MBR destinationTo specify a destination disk:1. Select the disk to recover the MBR to.2. Click OK.Volume destinationTo specify a destination volume:1. Select a volume or unallocated space where you want the selected volume to be recovered to.The destination volume/unallocated space should be at least the same size as the uncompressedimage data.2. Click OK.All the data stored on the target volume will be replaced by the backed up data, so be careful and watch out fornon-backed-up data that you might need.When using bootable mediaDisk letters seen under Windows-style bootable media might differ from the way Windows identifiesdrives. For example, the D: drive in the rescue utility might correspond to the E: drive in Windows.Be careful! To be on the safe side, it is advisable to assign unique names to the volumes.The Linux-style bootable media shows local disks and volumes as unmounted (sda1, sda2...).Volume propertiesResizing and relocatingWhen recovering a volume to a basic MBR disk, you can resize and relocate the volume by dragging itor its borders with a mouse or by entering corresponding values in the appropriate fields. Using thisfeature, you can redistribute the disk space between the volumes being recovered. In this case, youwill have to recover the volume to be reduced first.Tip: A volume cannot be resized when being recovered from a backup split into multiple removable media. To beable to resize the volume, copy all parts of the backup to a single location on a hard disk.PropertiesTypeA basic MBR disk can contain up to four primary volumes or up to three primary volumes andmultiple logical drives. By default, the program selects the original volume's type. You can changethis setting, if required. Primary. Information about primary volumes is contained in the MBR partition table. Mostoperating systems can boot only from the primary volume of the first hard disk, but the numberof primary volumes is limited.If you are going to recover a system volume to a basic MBR disk, select the Active check box.Active volume is used for loading an operating system. Choosing active for a volume without aninstalled operating system could prevent the machine from booting. You cannot set a logicaldrive or dynamic volume active. Logical. Information about logical volumes is located not in the MBR, but in the extendedpartition table. The number of logical volumes on a disk is unlimited. A logical volume cannot be
