Chapter 7. Creating a Dial Plan7-6 ATLAS 800 PLUS User Manual 61200226L1-15. Select the Out (Outgoing) # Accept submenu. Enter $ in the number field.Leave all other selections set to default (Enabled).6. Select the Out (Outgoing)# Reject submenu. Since no outgoing numbers needto be rejected at this port, no entry is required.7. Select Interface Configuration (Ifce Config) submenu. Select the PRI switchtype (National ISDN).8. Press ESC to back out of the connection to the index number column.9. Type I three times to insert another three connections in the list for the BRIlines.10. Select Slot 1/ Port 1 for BRI A. Enter the Outgoing Accept and Rejectnumbers as in steps 5 and 6. The Outgoing Accept numbers have two entries:888-01[0,1]X888-012011. This allows all numbers 888-0100 to 888-0120.12. Navigate to the Interface Configuration submenu. Select the BRI switch typethe network is using (National ISDN). Descend into the SPID submenu andenter the SPID numbers and phone numbers which match the networkprovisioning for this BRI line.13. Press ESC to return to the Index # column.14. While on the entry for BRI A, type C to copy the entire BRI A entry.15. Move to the next connection list entry and type P to paste all of the BRI data.Move to each field and modify as appropriate for BRI B.16. Repeat 13 and 14 for BRI C.17. After completing the network entries, the network connection map shouldappear (see Figure 7-4).Figure 7-4. Completed Network Map
