Chapter 11. Dial Plan61200305L1-1 ATLAS 550 User Manual 11-31Figure 11-10. Call Routing Table for Routing Using Call Party NumberP KT VOICE The ATLAS 550 provides the same level of capability for packet-switchedvoice as originally provided for circuit-switched voice.IFCE C ONFIGURATION (under D IAL P LAN > U SER TERM or N ETWORK TERM) setsconfiguration parameters for the endpoint. These parameters vary by thetype of port selected. The following section describes the configuration op-tions available for packet-switched voice (see Figure 11-11).The first step in configuring the D IAL P LAN for packet voice is to selectN ETWORK TERM or U SER TERM. Refer to Connecting Packet Endpoints in FrameRelay on page 11-28 for determining whether to use N ETWORK TERM or U SERTERM. (See also Menus for Network Termination on page 11-33 and Menus forUser Termination on page 11-34.) Once this selection is made, a number offields become available. These fields are discussed in the following sections.Figure 11-11. Packet Switched Voice OptionsS LOT /S VC Write Security: 3; Read Security: 5Select PKT VOICE as the service.PORT /PEP Write Security: 3; Read Security: 5Select the port/packet endpoint that you want to configure.S IG Not used for packet voice.IN #A CCEPT Write Security: 3; Read Security: 5Configured as defined in In#Accept on page 11-6.O UT #REJ Write Security: 3; Read Security: 5Configured as defined in Out#Rej on page 11-8.IFCE C ONFIG Write Security: 3; Read Security: 5Provides interface configuration parameters (see Figure 11-12).
